All posts made by ashtonsser that members have liked.
Hydraulic is a good solution. Just sayin. Lol
Ditch the Cometic gasket, ditch the arp main studs and head studs. Get GTIR main bolts from GregV, Get Mazworx headstuds, and either use an OEM VET gasket or get a better gasket such as Cosworth (o...
Ditch the Cometic gasket, ditch the arp main studs and head studs. Get GTIR main bolts from GregV, Get Mazworx headstuds, and either use an OEM VET gasket or get a better gasket such as Cosworth (o...
Its just a rear main seal housing. Put a wanted ad on the forum and im sure someone has one that they can send you. Not a big deal other than pulling the trans off. Do not weld that or use jb we...
Its just a rear main seal housing. Put a wanted ad on the forum and im sure someone has one that they can send you. Not a big deal other than pulling the trans off. Do not weld that or use jb we...
Its just a rear main seal housing. Put a wanted ad on the forum and im sure someone has one that they can send you. Not a big deal other than pulling the trans off. Do not weld that or use jb we...
Thats from them ramming them on with a gun and not hand threading them first. People get cocky when they do things repetitively and they think they can get them straight every time. NO! I always ...
Yep, dont clean it unless rebuilding the entire motor. Last thing you want is that sludge to clog the smaller oil ports in the block, head and valvetrain. Leave it alone and just change the oil f...
hahaha, no car is getting turned into a daily driver again. So im putting a full exhaust on with the new setup.
Actually instead of bolt on if you could do 3" v-band connections they would be s...
And the party continues..... :)
The thread two months ago pretty much sums it up and answers all the questions. Even Im starting to get bored and dont come on the forum as much....Doesnt change...
he meant p12. No, the comp clutch comes with a bearing to install into whatever throwout bearing your currently using. He sent me his tob in trade for mine because we were under the impression we...
Went to a local car show this past weekend and put another 200 miles or so on the car getting about 41-42 mpg :)
[url= URL=http://smg.photobucket.com/user/ashtonroche/media/284387_1015135228158...
BECAUSE RACECAR
Most people eliminate for the cleaner bay, easier to work on, weight reduction, power gain and the list goes on. Out of all the VVL swaps ive done, AC remained in only 1 and tha...
Yes, but ill sell you a set of adjustable gears that wont fall apart, that wont loosen up and lose time. I have my set of CS Adjustable gears, just look them up if you havent seen them before. On...
So just grinding the axles down after the splines to allow it to slide all the way in should work just fine then. That's not too much to do. Just one more thing to add to the mass axle/hub confus...
Lol, weak ass k series transmissions. Looks like there is a lot of room for improvement. Keep at it man.
Id take the state with no emissions but illegal marijuana any day any time. Never done it, never had the desire to, never want to, and never will. However, I am into modding cars and so hell yeah...
Id take the state with no emissions but illegal marijuana any day any time. Never done it, never had the desire to, never want to, and never will. However, I am into modding cars and so hell yeah...
Went to a local car show this past weekend and put another 200 miles or so on the car getting about 41-42 mpg :)
[url= URL=http://smg.photobucket.com/user/ashtonroche/media/284387_1015135228158...
Yes, starter doesnt matter being a de/det....any sr starter will work
Went to a local car show this past weekend and put another 200 miles or so on the car getting about 41-42 mpg :)
[url= URL=http://smg.photobucket.com/user/ashtonroche/media/284387_1015135228158...
Oh and on the Altima shifter the only modification I did to it was at the back side of the shifter there was two raised posts at the corners that are for the stock center console/armest trim to bol...
Thats not the one I got from you is it? lol. Cuz you can definitely fit a dual core aluminum radiator in there with it.. Just gotta slant it just slightly forward a bit. No biggie and anyone wi...
Went to a local car show this past weekend and put another 200 miles or so on the car getting about 41-42 mpg :)
[url= URL=http://smg.photobucket.com/user/ashtonroche/media/284387_1015135228158...
Went to a local car show this past weekend and put another 200 miles or so on the car getting about 41-42 mpg :)
[url= URL=http://smg.photobucket.com/user/ashtonroche/media/284387_1015135228158...