All posts made by Sentraga that members have liked.
I would want to trade if my side was up to par with what I was receiving. Sorry
My daily NX is FAR from an even trade for a stock SE-R
The other NX is complete and turns on but that's about it, not yet worth a trade for an SE-R
Damn it! I have two NX with TT but neither are stock :/
How to install TDMImports Rigid Collars
I'n case you haven't figured it out(took me a while to understand what was going on here also)...
All you're changing is the rotor drive so that the distributor accepts the RR rotor.
It's this pie...
To both Jordan and OP:
If you order non-ABS rotors you will get SE-R rotors.
Whether the car has ABS or not does not matter, if you want the correct AD22 rotor you have to order the "ABS" rotors.
...
To both Jordan and OP:
If you order non-ABS rotors you will get SE-R rotors.
Whether the car has ABS or not does not matter, if you want the correct AD22 rotor you have to order the "ABS" rotors.
...
He wants to know how much HP standard 17mm rod bearings will take.
Which has already been answered.
Completely off topic but... has anyone noticed what subforum this thread as well as the last Nismotronic thread have been posted in..?
I'd never even seen that vendor...
JKTUNING
Collector is where the secondaries meet
As per rule #4 and #9 I don't think this one is allowed
We can vote on it though
I say no, as you also have to be able to prove you're in your Nissan to begin with
It'll come back around... eventually.lol
Maybe...:rofl:
https://imageshack.com/a/img16/3056/rge1.jpg
Courtesy of member Dala, the hatch spoiler
http://www.mijnalbum.nl/Foto-GCUXDYTA.jpg
Courtesy of member KdubL, the MS Designs rear spoiler/EDM Sport re...
ABS only has two ports for lines(front and rear)
Non has four (two fronts two rears)
Kyle - All american(this side of the pond) B13s have the same transmission mount, whether it be a 2.0 or 1.6
I'm just as surprised to see a different mount on that NX
Yea I was wondering about your post also, as it wasn't showing up.
But welcome to the forum :)
Kyle - All american(this side of the pond) B13s have the same transmission mount, whether it be a 2.0 or 1.6
I'm just as surprised to see a different mount on that NX
You're hitting launch control limit because the ECU isn't seeing speed.
Reconnect your sensor.
You're hitting launch control limit because the ECU isn't seeing speed.
Reconnect your sensor.
Sleeves and washers are for the rear as the B13/14 spindle is longer/thinner than what is required for these new hubs.
Unisa Jecs sells the sleeve and spacers by themselves also, and he has the pic...
The part numbers and such were provided by Canx2k in his how to thread.
All I took from his thread was what I needed to have it made at a local hydraulic hose shop(technically a forklift repair cen...
He has them for the 6spd axles AKA Big Head Hubs
(From his other thread)
http://www.sr20-forum.com/tdmimports-kuo-s-garage/62981-tdmimports-kuo-s-garage-5-lug-bolt-kit.html
This would be very hard to do as there are several variations of the cluster, all with different pin outs.