No refund on my Paypal til this date!!
Then he lied on the PM when I asked him about the shipping and he told me that the valves were already shipped!!!!
I opened a paypal case then escalated to ...
Lol. I thought I was quickly becoming the villain. Seriously though, I agree with what you said. I lot of guys did get into these cars because the used entry price was inexpensive, and parts were c...
Ive seen spec, CM, Competition disks all do that. I used to have an ACT 4 puck unsprung with Extreme PP in my SE-R when I first turbod it and that disk never failed. It got old and worn from many...
After you get some miles on that beam be sure to recheck the toe. Joe was telling me he's seen more than one mechanically bent beam go back to being negative toe after some use. That why he uses th...
I dint have same luck!!
Opened a paypal claim I know its just $42 for a set of valves but hey!!!
If you dont have time to ship them DONT OFFER THEM!!!!
Or tell buyer otherwise and refund the mo...
2.34" in the front and 1.59" in the rear below stock. If you want it to handle/ride with any sort of grace, I'd raise that sucker a good inch all the way around. Let the stance guys laugh until the...
sorry havent been on in a few days, but i had west end alignment in cali bend my beam. their supposedly very good at it, they are the ones that bent mike kojimas b14-15 race cars. the offset bushin...
Hi Kyle, not yet as I put P11 chassis on the side because I got N14 race car which does need much more attention. Still have in mind to do P11 B6 Bilsteins with custom mounts and BC racing springs....
Literally everything updates with upload changes, including the general purpose parameters (RPM, TPS, ECT, etc). The update happens so quickly, that literally the update box is barely visible and a...
What Kyle said,except,you do also need to unclip the brakeline from its bracket to get it to swing far enough to get the axle out.
No need to mess with tierods,or calipers or anything else.