coach, I did this last night on the passenger side. One thing to note: on the P11, you will have square lock washers which prevent the Inner Rod from "walking off' the rack itself. I heard of them ...
Ben, I'd like to thank you for taking the time to document the troubles, and for following through and posting the resolution; I can't tell you how many threads I have searched, looking for the con...
Here is part of the reason why I stopped updating this thread (the other part is that I'm lazy as hell!). So check it out, give it a read, and go tell your ugly friends and their dirty cars how mu...
Actually any flange head bolt will work as long as it has a surface area close to the stock washer or any other thick washer like the stock ones as said above. I had to use bolts on a couple manifo...
Yep, the toe was out on my right front tire. Fixed it in my driveway, and she's not pulling when I accelerate. Need a full alignment, but it will work for now.
Anything open defeats the purpose and if you run one port open, you may as well run them all open. The best scenario is to buy two legitimate catch cans like the saikou michi or Radium Engineering...
I told GregV about the seals and he said he would check into stocking them. I suggest anyone needing them, give him a call and let him know so he'll put getting them higher on his priority list.
They came a little while ago.
Either the fit is tight and it makes drag... or i messed up the bearing from pounding the shaft back into it....
I'll know after i install and drive. But I have confi...