Boostlee's Likes Given

Done

Some people don't care to be the ones responsible for defaming a company, some people get tired of arguing, some people don't like giving out information, etc. I personally like sharing informatio...

some company is not worth supporting, especially one that talks shit about our community over and over and over again.

my edited post #30

a ball joint with a longer base but same length shank is...

Giving up cars for a fiance? It can only go downhill from there!!!

Actually it's a learning experience for myself. It's an online forum for information to be shared and discussed. :)

hammerin hank, does it make more sense now on why Keo and Boostlee objected to...

SR20VE+T E85/93 Comparison (Log manifold/GT3076R/NismoTronicSA)

Pull the head and check the gasket and deck for deformities. Who installed the sleeves? A bad sleeve job will cause continued head gasket failure. This sucks man I hope you get it squared away ASAP.

read post #1.

Glad to see it's doing well....

I'm sure it brings back some memories for Boostlee as well.

Unfortunately, you cannot use an ostrich emulator as it is a 28-pin emulator and the JWT chips are more like 32-34 pin chips.

If you need any other help with trying to get the car to run a bit b...

and don't forget, it's not even done right.

They are hank, it's at a different angle. You can see the legs in the one with coilovers.
tops are rear, bottom are fronts.
http://i102.photobucket.com/albums/m109/charleekeo/awrhousing2_zpsbee675f...

ast ftw

Koni race insert Coilover housings

The life of an average Nissan Sentra/200sx/G20 owner:
98% of the time is spent on the forum buying parts or talking about fixing their car
1.5% spent staring at the broken car
0.5% spent fixing ...

load up a sr20de TCD and set the injectors to what you have, then goto the setup tab --> MAF LOAD --> vq table and set your maf.. when your done with that save it as your own (dont save it over the...

FYI, When I had my beam "bent" by 2J, he told me he wasn't going to sell the panhard as a DIY due to the complexity of the install. It's more than welding in a few chunks of metal and a rod. The ge...

Don't get me wrong, I don't like the SRL setup at all. But with the right spring rates and swaybars, it's not all that bad. Mike K and Joe from 2JR, all have won races and even set records on an ...

Yeah they probably did it right then. How low is your rear right now?



That's probably it, thrust angle gets real bad if you lower the car more then 1".

As for the bushing binding, I actu...

Well the reason I asked... Is because you wouldn't see it during a "clutch job"...

A sprung clutch is more forgiving to misalignment.

Damper won't fix that... That is a serious first order alignment and/or run-out issue.

i dunno, ask the crazy Russian

nothing a little throttle cant fix!

Are you kiddin' me? If that was state side it wouldn't have lasted a day at that price. If that is indeed built to the same spec as a BTCC car, there's probably $150-$200K in that car. On track tha...

IAT density correction provides a means to apply a portion of ECT to the IAT measurement to more precisely calculate the actual temperature of the air entering the combustion chamber.
The calculat...