Dave_SR20's Likes Received

You're going from a baller setup to a baller setup

I was cuttting high 1.7's on the 15" Goodyear.

You're going from a baller setup to a baller setup

I used Honda Tech... Your number 1 source for use racing parts

I used Honda Tech... Your number 1 source for use racing parts

If she's old enough mail his sister to repay in sexual favors lol

I'll be happy enough just to make it out there

If I don't blow up on the dyno or track test it should be interesting

I'll be happy enough just to make it out there

If she's old enough mail his sister to repay in sexual favors lol

If she's old enough mail his sister to repay in sexual favors lol

If she's old enough mail his sister to repay in sexual favors lol

There's no doubt that your car will be tuff to beat. You've got consistency on your side for sure

If I don't blow up on the dyno or track test it should be interesting

Harness Service?

There was a fair amount of interest in the B14 as well. All i got was the drawing for the B13 so they can use that. If you need more drawings send me your emails

where is the dislike button? You're a man! We never NEED anything when we buy it!lol

I want a welder too but i need a bigger garage. Houses are cheap over here so when i buy i will get one of them metal pole barns installed in the back

Contact GSpec. He has a thread with all the PNs

You see rust but Bes sees weight reduction!:bigthumbup:

Any good metal shop can cut that out

You see rust but Bes sees weight reduction!:bigthumbup:

Twins is not necessary even at 500hp. We have one in our bracket car and seems like everytime we leave on the 2step another bites the dust. Most we can do is heat treat gears, weld the case for cra...

^Good MPH for your setup. If you get your 60' down to 1.8 you should be around 13.10

Completely. This ties in with what Ben said. Shift on the right curve and it will be butter