All posts made by Dave_SR20 that members have liked.
chapnutz1 Don't worry it bro. I'm not tuning over 30psi.
I'm going to call out Chap....hopefully you get motivated for a spanking big man
[color= COLOR=silver]- - - Updated - - -[/color]
Its all in fun even without S4's
I'm going to call out Chap....hopefully you get motivated for a spanking big man
[color= COLOR=silver]- - - Updated - - -[/color]
Its all in fun even without S4's
Yeah seriously bro. Come hang out. We understand if your car can't be there
I'm sure they would get something started with half down + a couple of months to complete so you guys let me know
I would say if you exit at 182 (turfway road) off I 71/75 there's I tons of restaurants with large parking lot for trailers
Should make the stop in Florence KY off I75 instead of Cinci. Too many small streets to exit in Cinci
Installed!!!!! Looks great and everything fits the way I thought it was but I can't confirm 100% until I have the actual piece made. I'll make it a bit wider where the bearing sits seeing that I ha...
Depending on how the testing goes. Kevwal will test it out
That was like Christmas... Not even knowing the trans had PAR straight cuts inside
Building a Transmission Gear Cuff for the P11 2000-2002
Closer.... Had the ID opened up to match the actual bearings that will be used on the gears.
[url= URL=http://s44.photobucket.com/user/evilempire18/media/Mobile%20Uploads/IMG-20140129-WA0003_zps...
The 3D ID printed a bit off from what it should otherwise it wouldn't have cracked.
[url= URL=http://s44.photobucket.com/user/evilempire18/media/20140130_172629_zpswffdz7qs.jpg.html][img]http:/...
Closer.... Had the ID opened up to match the actual bearings that will be used on the gears.
[url= URL=http://s44.photobucket.com/user/evilempire18/media/Mobile%20Uploads/IMG-20140129-WA0003_zps...
Closer.... Had the ID opened up to match the actual bearings that will be used on the gears.
[url= URL=http://s44.photobucket.com/user/evilempire18/media/Mobile%20Uploads/IMG-20140129-WA0003_zps...
Had the same CNC in the race car but never go around to installing it. You would stage and just hold it back slightly whiles the car is in first. Once the 2nd orange light just let it go and dump t...
It shouldn't give you any problems at all. Did it match up in length and shaft diameter with the old one? All it would be is screwing it on to the inner tie rod and tighten the bolt on the spindle ...
Thanks Bro. Got to love 3D Printing. Still waiting on the input shaft bearing to come in but here is what the cuff will look like minus the bearings
[url= URL=http://s44.photobucket.com/user/evil...
Thanks Bro. Got to love 3D Printing. Still waiting on the input shaft bearing to come in but here is what the cuff will look like minus the bearings
[url= URL=http://s44.photobucket.com/user/evil...
Thanks Bro. Got to love 3D Printing. Still waiting on the input shaft bearing to come in but here is what the cuff will look like minus the bearings
[url= URL=http://s44.photobucket.com/user/evil...