1fastser's Likes Received

No... the distributors are not interchangeable between the SR20 & KA24.

Soldering would be fine but make sure you put some heat shrink over it first...or you could cut it further back, to get fresh clean wires, and add a new piece of wire cut to the length you want. T...

Soldering would be fine but make sure you put some heat shrink over it first...or you could cut it further back, to get fresh clean wires, and add a new piece of wire cut to the length you want. T...

Still doing this? Lemme know when u come through Texas...I've got 2 B13s in need of tint... an NX and a 4Dr.

You can use the stock fan shroud and an aftermarket slim fan for a stealthy oem look...seen below.

https://lh3.googleusercontent.com/kZPGdHyXuPUPiWI9_1hu5qppTqB4Z7G58SMy1tWDjQc=w640-h480-no

I had...

Will work for head!

Installed the other wheel bearing (pass.side) on DDB. It had a single, very large pit in one spot. Also, noticed noise coming from the auto tragic tranny in D only... :*(

My sentiments exactly.

Well that's because you were rode hard and put out wet...but it happens to the best of us!

:beer:

Unlike go-fast parts, talk is cheap...

Unlike go-fast parts, talk is cheap...

A couple pics...

https://lh3.googleusercontent.com/16vbgnY0-gZf8LkJEcrk95SpHd0G8lRMg2Psutf57LM=w1084-h639-no

https://lh3.googleusercontent.com/bwhsAKFJh7K0PLdBEeaTfSfLAguzl1pmB-XqGCY9pv4=w113...

A couple pics...

https://lh3.googleusercontent.com/16vbgnY0-gZf8LkJEcrk95SpHd0G8lRMg2Psutf57LM=w1084-h639-no

https://lh3.googleusercontent.com/bwhsAKFJh7K0PLdBEeaTfSfLAguzl1pmB-XqGCY9pv4=w113...

Yup, I missed letting Keo meet me. :D I didn't miss the skrimps tho!

These are right up your alley.

I thought it was obvious but I guess just to everyone else.

speedricer !!!

:dunno:

speedricer !!!

:dunno:

speedricer !!!

:dunno:

Kyle Are you gonna donate that jacket you won from Chappy last year? :rofl:

:racer:

Where's the slap button?

If I had that kind of time I'd be driving a '91 SE-R w/VET to the convention! ;)

I bet the buzz is just in his head! :dunno:

Don't forget to add a vulgar, anti-wheel hop message inside the bell housing.

^This is very important! Pulling a deep vacuum (25-30 inHg - inches of Mercury) on the system and holding it for no less than 15 minutes is a standard evacuation procedure. And please make sure y...

eggman see post #2

If you still have the original condensor, I'm guessing it's clogged with 20+ years of debris...and while your right there you might as well replace the drier.