All posts liked by OnTheChip
A general rule of thumb for a speed density car is that your fuel table will "follow" your torque curve to a certain point.
Since your load values will stay much more stable with the map sensor ...
Good to know. I will get some sensors installed and start logging.
Thanks John, you are always a big help and have a great product, I cant say it enough.
How to: Pass smog (Nismotronic+Wideband)
Here's a pic of my temporary install, so I'll get used to logging the values. Don't worry, I'll tap a dedicated port for it later on, and get rid of the clear tube :P
http://i.imgur.com/mU7DDzz.jp...
Superb! I just got a 3bar MAP sensor & IAT sensor in the mail, time to convert to speed density!
This fits nicely because I understand more of NEMU. (and my feet are barely wet)
http://mashable.com/wp-content/uploads/2013/07/Anchorman.gif
Well I went over the entire system and found no leaks. I took the boost controller apart and it's fine, but then I figured I'd see how well the sintered brass filter on the bleeder port flowed........
The ALT injector setup has no effect on your air/fuel ratio. The ALT injector size is used when you want to switch between injector sizes quickly, for example with a switch (to run different fuels)...
NismoTronicSA Update: 3.12.002 | Wideband AFR conversion and Recovery Files
Your my hero. I didn't even know this was possible. Thanks you guys rock.
I should have noticed this lol I have read over the help section a ton of times. I corrected this and now I'm good thanks ...
well so far this is working great on boost by gear all set to 8psi which is actually just about spring pressure, the cars pretty much ready for the dyno where we can dial it in :)
JKTUNING you...
MAF replace and all is well. Car runs drive and pulls great on a whopping 4psi. MAC boost solenoid driven by Nemu is working so time to up the boost and tune. I can already tell that this 6spd swap...
EBC setup -- (ecu based boost control)
This is also covered in the FAQ section of the web site.
NismoTronic - Nissan ECU Tuning
Registered, should be well worth it.
Registration Done!!
I've been contemplating for a long time to attend a class like this, the hands on and discounted harware did it for me!
Thanks guys for putting this together
PS: i plan to ...
I'm only 2 hours away but even then it's coming out cheaper to just get a room instead of spending money on gas going there and back.
This trip will probably cost me more than I paid for NEMU by the time I pay for the class, hotel and, rental car but I want to learn as much as I can about this so I can get the most out of the NEM...
Hey JKTUNING, thanks for helping BenFenner understand some of the powah of NEMU capability. I saw what you have done in person with it and I find it extremely similar to anyone else whom I have wat...
NismoTronicSA Tuning Class: May 23-25th 2014
Yes! I would love to understand all the fine detailed stuff, like the accel/decel fueling and other random bits and goodies. General tuning tips can't hurt either..
edit: annnnnd I'm registered
Send it to john and just go with nismotronic $550.