All posts liked by OnTheChip
You made the right choice. I started tuning on the NEMU and it is easy to use yet there are enough features to really dial in the car to get it to run correctly. Read a lot on it and take your time...
nemu let me diagnose a faulty TPS within 10 seconds. and it did it twice, once by looking @ rpm with ignition on and foot not on gas (set launch holing 2krpm @ what is supposed to be 0% throttle o...
Yes, the TV2 and RD1 are both supported with NismoTronicSA.
TunerView LCD, NismoTronic - Nissan ECU Tuning
%60 on %40 off
@ or above 4400rpm, 4000rpm off
the issue i ran into was with too low of tps % vvl was turning on and off while going up hills, like say i wanted to maintain a certain speed, on...
When using boost by gear the ECU will use a specific duty per gear.
A gear is determined by the VSS and RPM. Because there is no input of gearing, tire seize ect Nismotronic has a paramter ca...
I want to bring this back from the dead :D
So I went for emissions yesterday and took my laptop with me to do live A/F correction. The tester had zero issues with my adjustments during the test ...
I know you didn't list it as an option but nismotronic should be on your list. If cop ignition is a must you can use a rwd sr20det ecu converted to nismotronic and have four coil drivers for cop or...
http://i110.photobucket.com/albums/n104/DaMasterPNut/SR20VE/SR1620VEECUpinoutdiagram.jpg
If this is correct, take pin 102 & 106 on the VE harness, and connect it to pin 11 on the ECU
Mid changes update.
Mustange Dyno at 237 WHP 172 Ft-LB corrected - Only the plenum and lower runners changed.
Mods:
Basic Xcessive plenum with stock VE TB
Gasket matched and smoothed lower ...
I put in the numbers that John recommended and all I can say is "WOW". Sounds great and built a lot more boost. I don't think I will need that much cause I already have issues with spinning the sli...
How are things running now?
I just installed mine and will calibrate the IAT tonight. Hoping to get some good logs in and setup my tables before winter hits. I will not have a MAF come summer. I...
I just have to bump this thread:
My car was behaving exactly like Evlnxr's, revving between 1500-2000-1500-2000etc. at traffic lights. Also had a high warm idle (1500), that couldn't be solved b...
http://s44.photobucket.com/user/Jybfan04/media/Dyno_zpscaa97ca2.jpg.html
S13 sr20det tuned by jk tuning
List of GM IAT and MAP Cars to yank from
As long as it isn't June 20th or anywhere within a few days of that date, I should be able to come.
The hotel is only about 1.5 hours from the shop and the track is only about an hour or so from...
There are a few things you definitely need to watch out for when using E85 or any alcohol based fuel in these older cars/tanks.
It tends to break down any of the built up sediment that is in the...
If you are using a nismotronic, you can use the gm flex fuel sensor. It will automatically adjust the tune to compensate for ethanol content in the fuel.
Old Tunercode was brilliant firmware!
regrounded map an iat sensors independently off the strut bolts and everything seems good now
Thank you for this link. This allows the 72-year old kid to easier understand this new fangled ECU stuff and be capable of equating it to how he would tune cars back in his time. I look forward to ...
4:th attempt
Result: Pass :D
http://i.imgur.com/yt5Wo8r.jpg
These were the readings. Nismotronic settings, "Enable Closed Loop" [X], "NB02 Closed Loop" [X].
I deviated from the first post...
From the sound of your post you dont know that Nismotronic SA supports MAP, flexfuel, and many other things...
You can also use it with COP but you'd need to get a S13 SR20 ECU to install the NEMU...
very helpfull update :bigthumbup: