I got the distribution block from Amazon today, hooked all 3 wires up to it securely, went back to the trunk to reconnect the negative terminal of the battery and....
It looks like its an inline in the engine bay cut-off switch so why wouldn't you get rid of the whole thing and just run a new positive cable to not have extra wires in there?
Do you happen to have a better pic of the wires as they hooked to the switch? There would have been no reason for a ground wire to be attached to the switch from the battery at all. The battery n...
I'm sorry, I might be a little wrong on the temp sensor information as its been quite a while since I've even touched an OBD2 engine. It might use two sensors, one for the gauge and one for the ECU...
Double check the connection of the bit actually attached to the sensor, they are only riveted on and I've had some come lose. Check the connector on the harness to make sure the wire isn't cut or a...
Prepping for finals. Project presentation with the head of the Engineering Dept, and maybe the school president. My school is kinda blowing this out of proportions. Looks like they are trying to us...
Guys, being that I'm subscribed to this thread and care about both parties involved, I think any updated build stuff (not related to the sale, but is relavent to Shawn's build) should be posted els...
Hmm, how much room is there from the jam nut to the side of subframe pocket? I'm wondering if I can cut out a wrench that would help adjust them without having to remove them.
I was not able to find detailed specs on this sensor, so have no idea what it's response rate or operating range for measuring air pressure are. I advise using a MAP sensor, just to be sure.
Contains unread posts
Contains no unread posts
Thread is closed
You have posted in this thread
Back to top