All posts made by yoshoto that members have liked.
1 |
12481515796166301 will exp Jan 26th 2020
All sr20 variants use 17mm rod bearings, except for the gtir which uses 19mm rod bearings.
yes SR20VE rod bearings are the same bearings as SR20DE either oem(use grade markings on crank and rod to determine bearing grade for each rod) or aftermarket like ACL or whatever type you like.
Dala it's what he has and by no means is it obsolete or antique.
Nismotronic is superior only because of its embedded code (tunercode).
A version of Tunercode was written specifically for the...
Battery voltage should be 3.7V I think but check it will be written on battery.
Did you run a verify using Emutility? Operation: Verify emulator Ram with file
Do this first, if it passes then...
on your daughterboard pics, you have one of the plugs unplugged a black and purple wire, is everything plugged in?
Are you doing this on the bench or in the car?
The emulator will work with o...
Dala it's what he has and by no means is it obsolete or antique.
Nismotronic is superior only because of its embedded code (tunercode).
A version of Tunercode was written specifically for the...
Port A is supposed to be for the Consult port. You can use "Nissan Data Scan" or "EcuTalk" or any other consult I software. EcuTalk is free and doesn't require installation, can be run from flash d...
Dala it's what he has and by no means is it obsolete or antique.
Nismotronic is superior only because of its embedded code (tunercode).
A version of Tunercode was written specifically for the...
A lot of what you will need is documented here CalumSult (mostly) Open Realtime ECU - CalumSult , English not being your first language, you are going to have a rough time, even people that are flu...
connectors are for:
Digital inputs (4)
High Current outputs (4) (I believe these are strictly on/off active ground and not PWM)
Analog inputs(4) 0-5V
may be labelled as DI, AI & HC on the connect...
The Calum RT has its consult interface built in. The Calum real-time uses a single USB interface that connects via an ftdi dual chip. This emulates 2 serial com ports. One com port is for the emula...
Dave,
On the other side of that FT232R on the DLP-IO8-G is a native serial interface (refer to simplified schematic on datasheet). That could possibly be connected directly to the NEMU via the sam...
Since the Inovate wideband is supported as a serial input(direct wideband), it should be possible to support added ADC via the MTS log chain. So if u added a SSI-4 or TC-4 or LMA-3 to an existing I...
Nistune is not an emulator in the true sense.
Yes it does realtime but you are limited to what has been defined in the tables and what areas of the ROM is allowed to be edited.
As I understa...
If you have the SR20VE or SR16VE ecu (Not the N1 version) and you have the suitable Daughterboard installed in that ECU (KBM50AA or equivalent) then you will need 2 Ostrich emulators to emulate the...
Clutch from the SpecV QR25 with 6 speed.
The gearbox is the same as yours except different bellhousing so the spline would be the same.
Ask at B15sentra.net, see if someone has one lying arou...
1 |