Keo's Likes Received

love the car, fuck that engine

1983 AMC Eagle SX/4 Sport

but Eibach ERS isn't that great.

^^ will verify 100% tomorrow.

Edit: for the record, Blair don't need the 8610-1436 to run hyperco. The 1436 will require a 2" maxima housing or equivalent.

The 8610-1409 is the b15 single adjust...

there is a sticky for the map conversion in the NismoTronic section.

OT, users can view there own edits and revert back to it was before also iirc.

OT, users can view there own edits and revert back to it was before also iirc.

OT, users can view there own edits and revert back to it was before also iirc.

OT, users can view there own edits and revert back to it was before also iirc.

but Eibach ERS isn't that great.

with a little bit of searching

Liquid Powder Coats

sounds like you have air in the lines.

but Eibach ERS isn't that great.

but Eibach ERS isn't that great.

these are not b14 coilovers, they are B15's. i bet you $1,000,000.00

For one, posting a picture of a b15 coilovers and sayings it's for a b14 dosent help.

Just because some groups of individual likes it don't make it high end. Do you have the shock dyno or know...

http://www.sr20-forum.com/200sx-se-r/32739-b14-aftermarket-exhaust-kit-system-choices-direct-bolt.html

^^ yup! Lol

I dont see that being High end

I strongly disagree with that statement also

same thing, lol

yes the header gasket are the same. are you planning on upgrading to a 3" cat? if not, I'd run the stock 2.5" gasket.

http://www.sr20-forum.com/200sx-se-r/32739-b14-aftermarket-exhaust-kit-system-choices-direct-bolt.html

http://www.sr20-forum.com/200sx-se-r/32739-b14-aftermarket-exhaust-kit-system-choices-direct-bolt.html

should be M10x1.0 and i did the same as above using the S chassis braided line.