All posts liked by Will
The 3 piece front should have significant weight savings as well as a wider design in the fenders so bigger tires can be fitted onto the car.
As for being completed it's the never ending B13 Sen...
Its a dying breed because Facebook provides instant answers and everyone just gets spoonfed answers(right or wrong). Nobody cares about learning,they just want an imediate solution..Its a sad socie...
Still talking turbo in the non-turbo section? :p
The machine shop I would be using have an SR torque plate, they maintain a few privateers btcc sr20s so that's not a problem.
http://img.tapatalk.com/d/14/09/30/rytemage.jpg
probably always needed the rod replaced..LOL
I'm ready and this time to run.
Collages are neat...
http://lh6.ggpht.com/_Ve2DaGK5dmU/S08CMDtWFxI/AAAAAAAAB84/p0Jdn4QlOok/s512/Expensive-watch.jpg
http://lh4.ggpht.com/_Ve2DaGK5dmU/S08CMQpDH7I/AAAAAAAAB88/08mwKLJqIA0/s512/...
Any Karting happening? :D My podium finish will not be denied!
reinstalled and got the cruise control working.....woot!
Who's still spraying??time slips inside
Try using a carbide burr for a dremel tool to remove the easy out and the remaining bolt. The carbide tool (Dremel PN 9955) should be harder than the easy out and the bolt material and will remove ...
i had the same//similar problem & it turned out that the lca bushin (front) was trashed...it looked fine, but the back side was gone..
I was in the same boat as you & decided to break everything d...
does the new shaft have that rubber insulator in the middle like a OEM one does? that def. seems to help//
I swap one on everytime i get a axle without it
ebinkerd speaks from experience. Heres a pic of what happens if the washer and castle nut is not there...it will eat the cotterpin eventually from torque,and start to loosen anyway leaving slop.......
LSD issues?
My car seems to pull pretty much straight but may 'skate' anywhere. Definitely have to pay attention. I can't say it pulls to one side every time or even pulls to a side at all. I th...
our cars should pull to the left under torque.
generally speaking, most cars should torque steer to the side with the shorter axle.
check your alignment, inner tie rods, axle nuts. if the ca...
Man, you guys need a welder when this happens! I'm a licensed mechanic by trade and all I do is weld a small "tit" on the top. Do this over and over till you have a nipple :) Then grab some vise gr...
^^ will verify 100% tomorrow.
Edit: for the record, Blair don't need the 8610-1436 to run hyperco. The 1436 will require a 2" maxima housing or equivalent.
The 8610-1409 is the b15 single adjust...
The key is rounded on the crank side. When you tightened the pulley the key was not seated correctly and ended up pushing through the pulley.
What car are you driving?
I used a 94 Altima clutch pedal and cylinder with steal braided hydro clutch line. I'm running a 6spd so the rest is all swap parts. The Altima pedal and cyl bolted rig...
Welcome .
Wow those are some really "period correct" aftermarket wheels on that SER.:bigthumbup:
I know most will think they are ugly these days.....but back in the 90s these were pretty popular st...