lynchfourtwenty's Likes Given

Did you blow 3rd in a B14/B13 or a P11/B15 gearbox?

P.S Great thread! Helped me in installing my MAP sensor (bracketry, wiring and all) in under 30 mins :)

N1 Cams? You're gonna need a good manifold to combat the added overlap. Owait, you already have that :P

Nice

those look tasty. wish i had a set

I'm guessing caused by whatever issues from yesterday morning? Since I couldn't get on then. Figured notifications were down again too.

Pretty repetitive issue...

This thread is one of the best on this forum! Good to see someone using NEMU to full capacity :)

Dan you are always mad about something. Chill out man.

Looks like the SR20 crowd was a bit thin. Even more motivation to get another one. Looking good.

Fuel pressure should be 3 bar with the vac line disconnected from regulator.

-------------------------

Oil pressure (@ operating temp)
Idle 11psi
3200rpm 46-57psi

Engine running
===========
~36 psi with the vac line
43psi vac line disconnected

Full Billet Upper Intake Plenum VE Feeler.....

Fingers crossed it keeps working!

I just put a slightly longer hose from the fuel filter so it gives some slack, didnt need the zippy tie. The straight fitting works fine for me, was happy to have it.

Use a black zip tie?

I wont deny I haven't had nearly as much time to browse the forums. Part of it is being busy at work, another part of it is playing with another toy (Subaru). I hope to get more back into the gro...

Awesome, I was going to ask that as well Boostlee!

Thanks Lynch, I'm possibly going to try installing mine tomorrow.

I would think so. Injectors are just solenoid switches. Solenoids use a electromagnetic coil to pull a ferrous pin and open the flow path. The polarity of the coil shouldn't matter

Sent from my S...

Oh, ok. Sounds good to me. :bigthumbup:

Sorry fellas, I didn't mean slow down the actual upload the the ECU .. I simply meant to slow down the timer for the sound :p

4:th attempt

Result: Pass :D

http://i.imgur.com/yt5Wo8r.jpg
These were the readings. Nismotronic settings, "Enable Closed Loop" [X], "NB02 Closed Loop" [X].

I deviated from the first post...

Make sure that turbo drain doesn't make a pee trap at the bottom before it goes into the block. That's how the SS was when I got it...it would back up to the turbo and smoke, eventually killing th...

did you check for birds with whistles? that happened to speedo a few times.

Header is mine. Bruce at Protech made this v3 of his 4-1 headers and his idea was to keep the collector above the cross member to make the car streetable to lessen then chances of bottoming out. Or...

The fellow hardcore shoutbox enthusiasts remember it otherwise. speedricer Keo 1fastser lynchfourtwenty

Black to ECU ground.
Blue to where ever you want to wire it into (ADC or MAF input wire)
Red to 5v source (either breakout box OR TPS 5v) - I suggest wiring it all through the ADC breakout box (w...

Here's a pic of my temporary install, so I'll get used to logging the values. Don't worry, I'll tap a dedicated port for it later on, and get rid of the clear tube :P
http://i.imgur.com/mU7DDzz.jp...