Scored a complete rear drum-to-disc conversion (knuckles, new hubs/bearings, e-brake cables, brake hoses, and the long ass bolts for the lower links) with P10/J30 Maxima calipers and redrilled roto...
Convention seemed like a good time for Jody and I to compression test both of our engines since we damn near dyno'd exactly the same values for HP and TQ.
Thank you Ben !! Finally...this is the type of response I was looking for...not trying to change up the whole setup...just need some temperature data.
And also thanks to everyone else for your con...
Here's the one I made for my car. I was able to keep everything. I almost was able to use the stock fans but i didn't have enough room for the WG dump pipe so I went with slim fans.
Just a little picture update.
The only thing I've managed to done this summer is part of the engine loom.
[url= URL=http://s233.photobucket.com/user/henning_90/media/SR23VE%20P10/_DSF0783_zpsa4ba...
It was a P11 bracket that was on there, put the original B13 one on the new motor, but still had a heck of a time getting the shaft in. The old bracket had been out in the weather for a while, I c...