Yup, completely understand. I'll need to get my rim/tire setup squared away BEFORE I start looking at spacer options. Currently looking at a 15x7 +43 with 225/45R15 tires. NX is lowered a bit but s...
The VE head has a threaded hole right in front of the oil passage. I think a bolt for the water pipe bracket goes there. It won't be used for that after this :D
http://www.sr20forum.com/gallery/da...
Replaced Passenger side axle. Attempted to replace driver's side axle, but didn't realize my one good axle was a non-LSD unit. My spare LSD axle had ripped boots, so will be r...
Same as eggman here. 2.5" Stainless NX catback from VRS. With resonator. Kinda expensive for direct bolt on...but mine has lasted me 8 years so far, with no sign of stopping. I love it.
They dont show it on the website but VRS makes NX catbacks or piping kits. I have one on my nx. Contact LikeTheMovies (Eric) is a dealer for VRS.
Also Andreas Miko
http://vrsexhaust.com/VRS_CAT-B...
Was too dark by the time I took some pics, so they didn't come out very well. I'll get some next early trip to my shop. Or maybe Saturday, as the NX has an alignment first thing in the morning.
Installed a B13 power steering cooler, B14 power steering reservoir, and a new pressure side power steering line. Thinking I may do the pump-to-rack replacement line when this one goes. Clean up th...
Everyone can try to help if you post a log from the start/bog. That way we can see what all your sensors are saying. Please upload a short log of the issue! :)
Took the Deviled Egg to the Ocean!!
First 100mile+ trip since the car has been put back together.She did good.
https://s16.postimg.org/b18s014gl/20160908_184046_HDR_1.jpg
I've got one of these 3-D modeled now. I've never used our 3-D printer. So I've got a wait my turn and do a test run. I'll let everybody know how it goes.
Decided I couldn't have a powdercoated suspension and a shoddy looking chassis. So I stirpped the entire underside of the car from all the suspension, brake lines, fuel hardlines, brackets, fuel t...
Just an FYI for future google searches... I found in the FSM in I believe the EF & EC section some information on the ECU's failsafe modes, one of which covered if the temp sensor wasn't reading c...
Stupid, stupid, stupid... I checked my relay wiring twice, but I checked it wrong... The problem is my new relay wiring. I disconnected the cable going to the ECU and jumpers the blue wire to gr...
FINALLY did something for the NX. Installed my S4HL's!!! Didn't get to drive it much besides back to its parking stall. Will go for a test drive today. Impressions to come.
Contains unread posts
Contains no unread posts
Thread is closed
You have posted in this thread
Back to top