jimbo_se-r's Mentions Made

Wow, I totally missed your oil change interval in your first post. I'm assuming you were doing such frequent changes because of the sludge? Once you run the flush through, I really think you shou...

Found the GSpec part, for future reference, it is here: custom steel Oil Relocation Block (w/90* filltings) sr20

I've got plenty of line and fittings from when I bought the original Tomei one, ...

ebinkerd

I understand exactly what you are saying, and I don't disagree with any of that. I've been working with electronics for a few decades. ;) It's not unusual to see various 'grounds' at...

Correct. I will PM you some actual log entries in the AM if that would help.

choke, I agree that a hit on either front corner may cause damage to the radiator the way it is currently mounted on top, I can't tell if those two small pieces directly on the radiator are flexibl...

I know that on the B13, there is a ground wire that attaches to the alternator body, I am not sure about this wire on the B13, but apparently it was on the B13 as there is not a great ground connec...

So, cruise to BBQ from Cabellas @ 11:30am, then K1 Carts after lunch? Is that the basic plan?

Anyone traveling more than an hour to get there (qzeek) should speak up if this time works.




Threa...

I've read the same thing, but doing that gets rid of the extra baffling in the RR valve cover, the baffling helps keep the oil from spraying around from the cams, so I'd really rather have this VC....

I checked Greg V's site and didn't find anything for the throttle body, only the intake manifold itself. Like Vadim did, I'm going with a Roller Rocker SR20, and the prior generation intake manifo...

I may have missed it, but while scrolling through this thread looking for proportioning valve information, I never saw a reference to [url= URL=http://www.sr20forum.com/technical-information-librar...

We didn't check, we just threw another fuel pump in, problem went away, chucked the old pump. The race was on, we had no time to coddle weak parts. ;)

The distributor rotor not spinning proper...