malaha5's Likes Received

rawdyrawdy is that a fujitsubo header?

The axles are new cardone select axles, and it is leaking front the where the seal surrounds the axle. I think it's because I pushed the seal in too far

the ga16 pump worked on mine also

https://www.facebook.com/photo.php?fbid=534255923308956&set=pb.100001736594903.-2207520000.1378274358.&type=3&theater
dont ever buy jgy. half the springs in mine were coming out after a year and a ...

lots of good info guys, thanks a lot. this thread went deeper than i expected. guess ill start jackin the ride hight up and hopefully the issue goes away until im able to install a panhard rod. ill...

lots of good info guys, thanks a lot. this thread went deeper than i expected. guess ill start jackin the ride hight up and hopefully the issue goes away until im able to install a panhard rod. ill...

what i found easiest to do with those bushings and motor mount bushings with the metal sleeve is to drill into the bushing multiple times circling the smaller sleeve in the middle, then taking a ha...

sorry havent been on in a few days, but i had west end alignment in cali bend my beam. their supposedly very good at it, they are the ones that bent mike kojimas b14-15 race cars. the offset bushin...

yeah that bushing needs to be replaced anyway so i would start there

just pop the ball joint out from the knuckle and then unbolt the two lca bushing mounts. a pickle fork will probably need to be used unless you can pop it out with a pry bar

make sure nothing is rubbiing or could rub under a load as the engine will shift and could push the axle into something. my buddy had an s14 that made a loud clicking sound after we installed a one...