What i like to do on any oem crank pulley that has rubber in it is to make a white paint line from outer portion to inner portion to provide a quick visual inspection if the outer portion of the pu...
Thanks for the replys guys. I'll be heading back to work on the car tomorrow. Got a couple spare motors so gonna pull the crank off to have a look and probably end up swapping one over for the time...
This forum has a spotty history with picture hosting. It had it, then it didn't, then it did again but it didn't work well, etc.
I've always thought a forum should not be involved with picture host...
I did not actually. I ordered a new one from Rockauto but it did not fit (sensor hole was not threaded), so am going to figure out where to get the correct one from. Just wanted to get everything r...
So, I pulled every last fuse and none were blown other than the 10amp for the gauges. I noticed my car is setup for the R/C Mirrors so I pulled that fuse and put it in the gauges slot. Well, the ga...
Took some more pictures today! I think these turned out okay.
https://lh3.googleusercontent.com/vd65Ow33J2iLx8XFi2fb6hbFXEqnUH1mlTxU6kWIcasqGoTMtFXoPhLW9K4YzSs-fK7wAltF1aT0ucHbroe0TC5m0NIOA2bx9Yt2...
Not much to update, ignition is superb! Been running the arduino ignition sequencer for quite some time, works really well on the road, no bugs at high rpm etc.
Yeah, it came as an "limited edition" package 'cuz that was the last model year for the b14 in Mexico,also featuring "limited edition" side badges and different corners and taillights, by different...
I have found out the rear slides out easier now while cornering hard and sudden lift throttle overseer occurs. It's not a lot of tail slide but it certainly helps to rotate the car. I have exper...