Thread: Quick Question on OBDII Harness and P11 VE Distributor Wiring

I know what pins/wires go where, so not asking anything about that. My question is about the little resistor that is inline on the ignition check wire on the OBDII harness (less than a foot from the 2 pin distributor plug). Do I keep or remove this when wiring in the P11 VE distributor plug? The VE harness does not have it (at least so far that I have found). I'm using the OBDII ecu (JWT) and harness, but the VE distributor. I'll keep searching as well, but I haven't found the answer yet.

Never mind... found the answer. P11 VE distributor has the resistor built in, the P10 OBDII one does not, so it is put in the harness. So I need to bypass it.

Bingo :-)

bumping this because I am trying to use the VE distributor in a P10 Obd2...
Could someone please post a link of the pinout/conversion needed to do this ? I ahve not had any luch searching thus far(how I found this thread)

Check g20.net it's been done many many times

Here it is:

HOW TO: wire a ve distributor into a de harness!!

Thanks! I did actually find it last night.Thats exactly what I was looking for