Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: VVL Activation problems.

+ Reply To Thread
Posts: 1-9 of 9
2013-10-13 23:09:16
#1
VVL Activation problems.
I'm using a msd 8969. With that being said;
I have yellow to the solenoids: >>> (orange& black, brown & yellow)
I have the other 2 to the battery
>>> (brown & yellow, green & red)

I have the red to the battery from the msd box

I have white to the rpm signal tapped into the blue w/ black stripe from ecu harness.

I have black to ground
>>> (intake manifold)

I have gray not connected to anything. I have a 93 sentra ser, & I'm not getting any pop. But when I touch the gray wire to the yellow the solenoids click. Any ideas?? Thanks
2013-10-13 23:48:26
#2
The yellow wire ties into the solenoids wires then connect the yellow/solenoids to a power source.
2013-10-14 00:21:21
#3
I have brown & yellow and green & red off the solenoids going to the battery.
2013-10-14 00:24:21
#4
U getting rpm signal on Msd switch

http://www.sr20-forum.com/ve/24037-how-wire-up-your-msd-rpm-activated-switch-your-vvl.html
Last edited by prtitan06 on 2013-10-14 at 00-28-37.
2013-10-14 00:30:02
#5
Oh never mind. I think the yellow wire(wire the other 2 wires off the solenoid to the yellow) acted as a ground signal on mine. I think thats how I had mine. White wire was RPM and grey went no where.
2013-10-14 00:37:33
#6
I'm not getting rpm signal on the box, all it says is te number 3 or the number 2. When it's idling at 900rpms.

& circa your yellow wire was a ground? I don't get it..
2013-10-14 02:23:44
#7
Maybe u tapped wrong wire for signal if u not getting on box. Mine was yellow n red stripe
2013-10-14 02:37:41
#8
Yellow and red from the harness?
2013-10-14 04:29:53
#9
It worked!!!! Haha thanks man!!
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top