Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: No spark after swap

+ Reply To Thread
Posts: 11-20 of 29
2013-04-29 16:22:23
#11
Originally Posted by 79Rod
check all grounds too. very important are the ones that are places at intake manifold
keep us informed


i extended the 2 small grounds that were under the IM on my highport to the top of the VE manifold. Was that the only one?
2013-04-29 16:31:57
#12
Originally Posted by circa.13
Originally Posted by naedtrax
02 sensor and igniter chip have the same plug too. o2 sensor has a gold middle pin loom side


Ill for sure make sure that it isn it. I have a feeling it's something really stupid I missed.


I have done this personally, and i was stressing about having no spark what so ever. Changed over the plugs to their correct places and had spark right away haha
2013-04-29 16:35:40
#13
...basically.
did you grounded battery to engine?
any troble code?
2013-04-29 16:40:53
#14
Originally Posted by naedtrax
Originally Posted by circa.13
Originally Posted by naedtrax
02 sensor and igniter chip have the same plug too. o2 sensor has a gold middle pin loom side


Ill for sure make sure that it isn it. I have a feeling it's something really stupid I missed.


I have done this personally, and i was stressing about having no spark what so ever. Changed over the plugs to their correct places and had spark right away haha

Just checked that and the plug that's plugged into the O2 sensor has the gold.
2013-04-29 16:42:47
#15
Originally Posted by 79Rod
...basically.
did you grounded battery to engine?
any troble code?

I didn't check the code on the ECU but then again I am sure it will because I had all the EGR stuff on before so I'll end up with random codes thrown. Should either the coil or distributor have a constant hot wire?
2013-04-29 16:46:42
#16
I check the voltage to the coil and I am getting 12v there...
2013-04-29 16:56:27
#17
Alright fellas I have this fat black wire with a red stripe that I am not 100% sure where it goes. I thought it went on the battery with the normal power wire but it doesnt look right to me.
Last edited by circa.13 on 2013-04-29 at 16-57-54.
2013-04-29 17:43:22
#18
Post some pics dude
2013-04-29 19:41:19
#19
I fixed the issue with the help of @lynchfourtwenty he pointed to a bad fusable link and I believe I had the fuel line backwards. Now I having a bigger issue with the trans. :/ never ending....
2013-04-30 10:56:03
#20
What issue are you having with the transmission now? Wish I was able to make it to help out last weekend =\
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top