1 hour of run time and the engine knocks!!!
Originally Posted by
squirlz By you asking this question, means you do not understand. you can assume all of this stuff, and you did. But obviously something is not right and nothing short of having everything measured will solve your problem.
Well excuse me!
I found out what the issue was.
The machine shop took too much material off when honing the rods.
After all my measurements, I will need .25 over bearings or new rods.
I will use the rods my buddy Cortrim1 is donating to me, and measure again before assembly.
Thanks for all the advice so far, negative or positive.