Thread: 88mm on a budget!! (Not on budget anymore!!!) New Dyno!!

^You have an 88mm build as well?

Yes

Going again to the dyno after two weeks

Nice, whats full specs?

C p12.5.1 88 mm piston .N1 cams .xceesive plenum and tri y header . Fidanza flywheel .. but it needs more tune and it is still on the first 500 miles

- How much were the pistons? What HG did you use?

^^^ He got a super deal on used cp pistons and a block already machined you can use either cometic or bored SR20VET gasket both cost the same yo can get cometic on any bore and thickness for $100 or bored VET for $100 new custom pistons from cp are $645..

how are the temps with the 88mm?.... whats the setup a the cooling system for the motor?

- Yeah the pistons went up big time. My 92's cost about $650ish. I have a bored 92.5 or 93mm VE HG. Should be fun once I put it together, but I'm liking this 88mm build. Just wanted to do some price comparing as sleeving a block puts you 1200 more above this build. Good luck guys, and happy tuning.

Just bore the block to 88. With stock sleeve temp is lower then stock and the stock guage