Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: Dynoed tonight

+ Reply To Thread
Posts: 1-10 of 13
2011-10-22 04:00:39
#1
Dynoed tonight
Ok well we just recently put together a white b13 with a shaved bay with a stock ve. So before we put cams and other bolt on's and head down for a marsh tune we decided to get a baseline. So the car is a stock ve with a ssac header , lightweight flywheel , and a custom cold air with a velocity stack. First pull we did was on motor the car made 166hp and was a little rich. So we decided to spray it I used the zex chart as a base I loaded in the 55hp jets and the car made 236hp then I did a little bit of a jet separation while keeping the same nitrous jet and the car mad a final number of 247hp & 225ft lbs with a air fuel of 11.9. All these runs where done on a dynojet.
2011-10-22 04:32:43
#2
the car stands alot to gain from some better parts.

a baseline of 166whp ? a lil low, bet youll gain alot from a good tune.

what parts are being put on it ? any pics of the nitrious set up or details ?

stratton.
2011-10-22 05:19:35
#3
The nitrous kit is an out of the box zex wet kit the one with the little box.
We plan on putting a set of kelfords in the car with supertech springs and retainers. Also swaping out the ssac header for a nice one and possibly putting a set of Sti side feed injectors.

This pic was while we where wiring it up but you can see the box.
Last edited by boostednx on 2011-10-22 at 05-23-42.
2011-10-22 10:26:01
#4
Not bad. I bet it runs well.
2011-10-22 12:42:15
#5
Well the car surprised me at the track it went 14.3@96mph with a 2.2 60'foot. That was on motor.
2011-10-22 14:26:20
#6
Good #'s on spray, though na #'s numbers are low.my numbers on with 75 shot single fogger no tune were similar 250/225 almost...my na numbers sucked too only 180 hp and that's with n1 cams...but I think a real tune would get those up..had the car tuned when it had sr16ve cams and it pulled way better than the car now with n1's....
2011-10-22 14:31:09
#7
Originally Posted by boostednx
The nitrous kit is an out of the box zex wet kit the one with the little box.
We plan on putting a set of kelfords in the car with supertech springs and retainers. Also swaping out the ssac header for a nice one and possibly putting a set of Sti side feed injectors.

This pic was while we where wiring it up but you can see the box.


You gonna run the Kelfords on a stock comp. 2.0
2011-10-22 20:06:33
#8
what size shot was it? also can any of the guru's say why the power peaks early and begins falling before 7k?
2011-10-22 20:20:12
#9
revvl-r im gonna guess cause its a completely stock ve. some head work, an intake manifold, some big cams and a legit header along with a tune will make the power peak higher.

stratton.
2011-10-22 20:23:43
#10
stock ve cams is why. That same shot with some n1's or kelfords in there would have been a whole different story.
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top