Thread: B14 VE Swap Throwing Codes

ok so the codes im throwing are
1. P1401 EGR
2.P0132 o2 sensor bank 1 sensor and
3. two codes for Crank Shaft sensor P0335 and P1336.

i know the 1st code can be taken care of by plugging in the EGR sensor in the harness, but does it still need some kind of vacume or block them off?

2nd code i take was the rear 02 sensor i plugged it in but its not in the exhaust, the tune deleted the sensor but i guess the ECU still needs to rear the sensor is actually there.

3rd, im guessing the sensor id bad, i do have a fidanza and im 99.9% sure its the correct one.

any other suggestions?


Im also preparing to do an OBDI step down that should take care of 2 codes. the rear o2 and crank shaft sensor...(please corrent me if im wrong)

info, suggestions, anything will help thank you...

1 Search for the EGR delete it works fine on odb2 ecu also on stepdown because it has no codes with obd1 ecu.
2 Looks like its the first o2 sensor it should say bank 1 sensor 2 or something like that
3 Im not sure what flywheel is in there.

Yes obd1 stepdown will get rid of 2 and 3 I only use my obd2 for emission.

any other suggestions???

1. 86K Ohm resistor and done.
2. I think its the front one thats tripping it. The rear does not need to be in the exhaust, as long as the ECU sees the heater and sensor parts of the O2 you are fine. I faked out my rear O2 and never had a light come on.
3. Wrong flywheel