Thread: kelford/ cam setting help please

Hey guys so heres the story.. i previously had kelords in my motor set at 5,0 i took them out and put regualr stock ve cams in and ran them for a while now i jus recently bought a set of kelfords the other day and i went to install them at 5,0 again but i had no compression so i went back and put them at 0,0 and now the car runs but im wondering why isnt it running at 5,0 anymore? i am 99.99999% sure i installed them right, motor was at top dead center, i even installed one cam at a time to make sure nothing went wrong so i dunno some help would be great thanks guys

what version ?

stratton.

they sed the new version so im guessing v2s since you said your the only one in the us with v3s i dunno how i would go about checking

also my spec sheet and the spec sheet on the kelford website are different.

Post ur spec sheet ? You may have v3s, kelford from my understanding no longer carries the v2s.

Also why havent you asked/ contacted kelford.

Stratton.

I tried calling but no answer, but i sent them an email to see what they have to say. I dont have anything to upload the spec-sheet, can i call you later today or tomorrow to see if our spec-sheets match? Or do you have a number for kelford that i can use? Thank you for your help.

pm me your number if anything thanks

They are really good at getting back to people if you can send Kevin at kelford an email

i sent an email i dont know if it is directly towards him do you have his direct email?

Sorry I have been super busy and had to separate from the outside world for a little while.

I will give you a call later today.

Cool