Thread: 20V valve cover PCV valve. What do you use?

Just to make sure, this is the same grommet and pcv that the VE valve cover uses... right?\



I went to the local parts store.... picked up a couple grommets and pcvs. I think the middle grommet would work just the same, but its in there good and i'm not going to fight to get it out... Only cost me $6 for both. (not including the extras)

Hey Ben who do I route the pipes??? seein how tha 20v has three

Looks good to me. When I installed mine, it was REALLY tight. I think you've got one that will work just fine.

This is how it is done from the factory, and this is how I'd do it on an N/A engine.

Here is my engine bay, should get rid of tha aftermarket oil separator??

Never mind Ben I found tha answer ;-)

2000-2002 Roller Rockers should be exactly the same, grommet and PCV valve wise.



How is that PCV valve doing, I was going to buy one, then I blew into it and it was passing air! Useless in that case .

the one i bought for a sentra and it did that too, so i returned it.

Then I found another one on the shelf that would fit in the grommet... and tried to blow thru it, and it was almost perfect... so i bought that one.

The part number is what it is. I have no idea what application its for. But I returned the one made for a 2001 sentra.

I tried a different number and it did the same, guess I'll just try OEM.

just a question on this picture

when i cleaned my TB,i found a small metal brush inside the fire suppresor hose...is that really part of the hose???