Thread: sr20ve intake manifold and the top feed fuel rail and IACC does not fit

sr20ve headworks - DeNismo - Photo.Qip.ru / id: vas










the IACC does not fit

Yea, custom steel "fixed" that problem by offering a spacer that goes between the flange on the IM and the iacv that puts the iacv at a different angle.

Custom Steel - VVL and N1 Top Feed Fuel Rails - SR20 Forum

PM Gregv, hopefully he can get them, although they arent listed on the website.

Although, I'm sure you can bend the tube enough to squeeze it in there...

now I see. I have ordered the rail from Greg, and he haven't told that I will need the spacer.

I did some more research and it seems the spacer was only a prototype and was never sold I guess. Just bend the tube

You can use the IACV off a 91-94 sentra w/ ga16de engine (plugs right in). It has the pipe on the top of the IACV not the bottom. I already had this lying around, so i didn't have to buy one and also solves this issue. This is the one i will be using even though i will be using side feed injectors. I'll post a pic in a few days.

You should post some good pics please.

can you show the pictures of the bent tubes?

It seems to me, that I can reduce the diameter and it will be insufficient

I have the aluminum spacer that will make the IACV valve clear the fuel rail.

I have about 4 of them but they are a little costly. You can send me a pm if intrested

What about doing what they do on the excessive manifoldsand just put two barbed fittings and you remote. Mount it...