Thread: CP Custom 92mm 14.5:1 Pistons

Just wanted to show off these beautiful slugs that just came in for a customer

I <3 dome. Lol

How pretty : )

and they said they could not do it.

beautiful!

Yeah, but this is for 92x92 so then could get the extra almost 1 point out of it from the extra 6mm stroke.

Plus I'm sure after claying the motor we will realize the reliefs don't need to be as deep as they are. But we'll see

they couldnt until i sent in juns piston from his 280whp motor. they werent able to find the old data to make it, even though i informed them they made it years prior.

i pulled a the piston out of juns motor and shipped it off to them. granted it was 90mm they used the same dome.

once they recieved it they cross refrenced the points in their data base and finally found the orginal blue print. mike told me it was the last one on his sheet lol.

so thank me .

stratton.

this styled piston was run till i think to like 10k at least on a 86 stroke and had no interference with kelford v2's so your more then good.

i dont think your gonna rev the motor to 10k. dependent on were it makes power, id guess 8500 or so. 9 to 9.5 should be fine on a stroker motor.

if you look at some of the 92mm / 98mm stroker cranks in some b series which have a worse rod / stroke ratio then us and are under square and they still wind it to 10-10.5k.

stratton.

the dome is looking VERY similar to mine