Thread: Help with AFC NEO please

I searched all morning but i can seem to find my answer, if this question has been asked please send me to the right thread. Thanks..

I just bought an apexi afc neo and I need a basic setup for:

SR20VE motor stock
SR20VE MAF
SR20DE OBDII ecu
Walbro 255lph gas pump

Any help would be greatly appreciated.

Thanks,
Jose.

hey man there is no basi set up every car its different......in mine I started at 0´s and then when up from there........using the buttdyno..........then I installed the WB it was so much easier

Ok, the map setting I leave it to 0's to set it later but I need to know rigth now what I have to choose on the screen ''sensor select'' (hot wire or pressure)? and what values should be put for ''in'' and ''out''.

How much percentage I have to put on the ''throttle point'' screen for Lo thr and Hi thr?

And finally on the screen of ''V/T control'' what values are recommended for ''Lo-Hi'' and ''Hi-Lo'' fields?

Thanks!

on sensor select you choose hot wire............in mine I use in/out 6/6.

*thr point its up to you I have 20 low 50 high

*Vt I have it at Lo/Hi 4900

Hi/Lo 4200

*por cierto mae lo hubiera preguntando en nissanclub lol

Awesome thx!

Jajaja diay mae no sabía que ud estaba en NCCR lol!
Por cierto ud es de Paso Ancho y tiene una R blanca con vvl?

great


PS..........el mismo man jajaja.........ud vive ahi por el ice right??? creo q ud era compa de mi hermano en el cole...........pura vida

Jaja que pequeño que es el mundo en este caso, si mae yo estaba en ese cole...

great


PS>>>>>>>>>.el mismo man jejeje.....ud vive ahi igual o vivia ahi por el ice right???? creo q ud fue compa de mi hermanillo (diego) en el cole???? south side rlz jaja

Y el ECU DE entiende el MAF de VE sin mover los in/out del SAFC? Los MAFs de DE y de VE son diferentes.