Thread: uht oh spegetti-O

You can also wind old timing belts around the pin for budget mounts. I've done casting urethane mounts twice and they work great. ITs a pita but hey it was $25 shipped.

Also you could get some G20 mounts at the pick n pull so you the car can stay running. They always have P10s.

Just buy the rear mount for now, that should hold the motor stable until you can do the rest.

Personally I always only go for the front and rear. The sides don't do too much.

i'll figure it out.. i jus need some cash

the passener side one does quite a bit.. if ya ever get a chance to drive a car with a blown one.. you'll be suprised hehe

Bone yard on Foster/205. If you are desperate just put it in your toolbox and carry it out.

ahh ya i know where that is

Take a ride out this week and we'll hit it up. Usually 3-4 P10s and they tend to have some good low mile parts.

Do it man. An ounce of prevention is worth a pound of cure, especially when it comes to those mounts. No more excuses.

found replacement rear mounts on rockauto for hella cheap, gonna start there

Just curious how cheap? The prothane rear is like $26 shipped. That's one pizza pie over there isn't it? Or a quarter pounder deluxe ;-)

I just remembered this is your gf' daily so yeah aside from the rear mount I won't go prothane. Will be too harsh for her most likely. So some good oem side mounts should do the trick.

ok from what i read the p11 rear mount is the same as the p10.. but i guess for some reason it only lists under the p11 on rockauto.. but its like 12$ before shipping so im guessin no more then 18$ or so.. an i can just bolt it in.. from there i would prolly get the passenger side next


edit: i think the cause of the over heating to start with may have either been due to the thermostat not opening.. we'll see..