Thread: Wiring Pathfinder MAF to B13 for vvl.

I did not see this one under Mikos thread so I thought I would provide some of the info. The part number from the MAF I used was 22680-5J000 and it comes from the 98-2000 Pathfinder with the 3.3 V6 motor.

Pathfinder Air Flow Meter

Pathfinder maf pigtail.
5v-White(inside shielded grey)
negative-Black(inside shielded grey)
12 v.-Black with white tracer

B13 Engine side maf harness. Note:Negative and 5v. orange wire are in the grey shielded insulation. So do not get the two orange wires confused.
12v.-Orange
Negative-White
5v.-Orange

I hope this was/will be help to any one that uses the JWT ecu that are programmed for the pathfinder mass air flow.

Great job on the post, but the MAF wiring post had all the info in it.

The thread did tell you how to wire up this MAF though. It does state the B13 MAF. It also stated that on all nissan 3 wire MAFs the middle wire is ground and goes into the sheilded wire, and the other wire in the sheilded wire is 5v read wire. This leaves one wire, which would be 12v posutive wire.

I thought mosr coyld figure this out if they read the thread.

Yeah, I know you covered the B13 wiring but I did not see the pathfinder maf. I did it today so I thought I would make a post.

What I was trying to say is that every Nissan 3 wire MAF is covered in the thread even if not listed. All you have to do is just follow the instructions before you get to the MAF wire colors.

****ing awesome man!