Thread: Post your VE engine bays

yes FWD for B13. can you take a pic bud? I noticed that the place where the stock ignition is the place where the solenoids for the VVL. so i am now thinking where will i place the stock ignition coil.

filthy as shit. Got tons of cleaning up to do. Making sure everything is 100% then I will carefully run hoses and wires to clean it up. Shes running good!

Holy intake pipe Batman lol.. MOAR PICS!

there you go bes!!!

Just stock ve with a big intake that's all.

Thanks boys. I'll get one of the local guys to do a shoot of the car once its done. The bay will look a lot better. The bay will look a lot better with lines tucked away. The intake pipe is a just a baby 4" lol. Will need a trip to Mark in CT to chico shine the bay lol

The car's been gone for a little over a week now. I didn't get a chance to take a pic. But I bolted it to the end of the solenoid block that bolted to the motor. You can unbolt the coil from it's iron mounting block. It has a couple spots where the bolts pass through it so you can use those holes to bolt it to the solenoid block. If you flip through the pages of this thread you'll be able to see a couple of B13's that have it mounted this way. If not, you'll have to source a longer coil wire and just mount it remotely along the frame rail. But again, it's easier to mount the coil if you separate it from its stock mounting block.

just a stock De with an oversized intake LOL...surprise!

someone should fall for it lol