Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: Post your VE engine bays

+ Reply To Thread
Posts: 171-180 of 695
2010-12-30 19:16:04
#171
This is mine engine bay for now until the weather gets better here ill do some wire tucking i just got the car from FL

2010-12-31 22:51:59
#172
Originally Posted by SE-Rican
Old School right here!!



Rob... what intake pipe is that?
2011-01-01 01:13:46
#173
Originally Posted by SE-Rican
Old School right here!!



Very nice! Running a stand alone? No maf
2011-01-01 02:40:11
#174




This is my N14 Pulsar SR20VE race car with the slide throttles.
2011-01-01 09:21:38
#175
What throttle body plate is that?
2011-01-01 10:37:21
#176
Originally Posted by Wayne
Rob... what intake pipe is that?


Me and my dude Lance actually made it out of a 3" u bend. Then I polished it up.

Originally Posted by tj5854
Very nice! Running a stand alone? No maf


Yes. EMS Stinger 4424.

That pic was taken over 4 years ago. Car has been down for well over 3 years now.
2011-01-01 23:49:49
#177
Dam Rob i wish mine engine bay was like yours so clean, good shit man can wait to see your car done 3 years is a lot off time
2011-01-02 00:11:17
#178
The Throttle plate is 45mm by an engineer in Sydney, Phil Ryall he makes them generic and can also make inlet manifolds to suit any engine. Plate only is around A$1000 from memory not sure what he charges for complete setup. He is a sponsor of mine so price for complete setup is something I have never chased
2011-01-02 16:58:34
#179


2011-01-04 15:01:12
#180
cell phone pic, but you get the idea.



built 9:1 comp VE, 01 P11 gearbox, GT2860R
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top