Thread: SR20VE motor wont start

Pin 35

no crank/start, I spliced the input (pin 35) and lined it to spliced into ground wire (pin 13)from the ECU. same results. a clicking. I guess I gonna get a new starter then. tough luck.

Is it multiple clicks, or just one click?

One click

Got the new starter today and installed it in, then weird
everytime I put the power harness on battery + the starter start to spin, still have key locked at aac, wont let me have the key back., tried started it, starter wont extend. might be missing a wire. eh?

Edit-
was the poer cable in wrong place, put the poweer cable at bottom of the starter. tried to start, same thing. a click. still waiting on some info about the 2 plugs and I hit the wall today

I rewired the clutch sensor switch to ECU, and it is still same, one of the ignition relay is clicking once everytime i try to crank. no spin in the starter either, though I got my key back, no key lock anymore. I believe there wires crossed or need to plug one of 2 plugs near the battery to let it crank and start, MM do i need to swap out with new relay?

trying to find it

ok on my sr harness the wire is black and white look for that plug with the black with white stripe. and on the ga plug it hass two black and yellow strped wires . so i have the sr wire going to the right side yellow wire of the ga harness. to to get me some clear pix so both harnesses

91 ga

[img][IMG]http://i338.photobucket.com/albums/n435/thugsterx510x/ga1.gif[/img][/IMG]

91 sr

[img][IMG]http://i338.photobucket.com/albums/n435/thugsterx510x/sr1.gif[/img][/IMG]