Thread: SR20VE 4-2-1 "budget" header

Do you still moving your shop, Charles?

^^^^

Yup, BUT! I am going to try to dig out a few of the headers that I can and get them shipped today. 3-4 of them I think. I still dont have my fab table up yet which isnt good because that means that i cant get anything done yet.

I will try to get it out today or tomorrow though if at all possible

^I thought about doing this, but it will set in my room and look pretty for awhile.............,until........... I GO VE!



^The ceramic coating is extra, but it is worth it!

Just an FYI to those installing this header on your B14, I had to pull the ac comp off and move it forward a little to get the line out of the way to put the header on. I tried bending the line but I didn't want to go too far. Anyway, with the header installed it clears everything just fine, it was just getting it into position that was the problem. Dont know if it was a fluke, but just a heads up.

Charles, you did a great job. Butt dyno felt a decent gain and the tone did change quite a bit, so much so, that I am afraid to go 3" now :o Yea......I'm a pussy

can you post some pix of the header installed since you actually have ac. I have yet to see any pix on a car that has ac. Are you using stock fans?

Ill post some pics, but they will have to be with my cell phone. My digi cam is at home 400 miles away. I only have the driver side fan in because the o2 sensor wires would hit the blades when using the ssac header. But I can tell you, this header WILL clear stock fans with room to spare.

wonder if there will b another group buy for those who missed out...

...........

Wheres my ASP logo man? cmon now!