Thread: neo vvl ecu pin chart???

anyone have a ecu pin chart for a '97 - '01 sr20ve engine out of a nissan primera???

Why don't you search a little bit? You'd get faster answers.
Is there something particular that you need?

It's been said that SR20VE and SR16VE share the same ecu pins.

SR16VE ECU





SR16VE.N1 ECU


Sorry for these not being translated but you get an idea.

SR16VE & SR16VE.N1 ecu diagram


Pin, Sensor and Wiring Output Signals

thanks now to translate

i have a '98 nissan 200sx(U.S.) that had a ga16de. i did a swap to a sr20ve(my first real project!!!) i got engine, transmission, ecu and harness. the only thing is that the color codes and different, still trying to figure out the three plugs under the dash on the car. which wires to splice into to get the engine started.

Have a look on this page.

You don't need to mess with the 3 small plugs in order to start the engine.
Did you get the CVT transmission?

i think it is a cvt transmission....would it be better to use a ecu and harness from a sr20de?? do i need to swap out stuff like the transmission, distributer, ect....sorry for sounding like a retard......its my first real project:o

i pretty much need to get the engine started, just to make sure it runs. i've had it for about 9 months now, its already in the car, but nobody here in town seems to know squat about it, or nissans in general, just honda. any suggestions?????

I'll help you out. sr20ve.co.uk Look in the electronics section, there is a pinout for the 20ve ecu.

i looked at that web, but is that the sr20ve that will be the same if its made in japan??? should i ignore the color codes and just go by the pin #'s?? it seems that the harness for the sr20de looks different on the web site as well.

SR20VE was a Japan only engine. All the ones in the UK are the same as you get in the US, EX-JDM. There is definitely the possibility that the UK sr20de loom/ecu etc are different from your ones though.