Thread: P11/B15 shifter rod and stabilizer for B13/b14 chassis

I can test it if you want

Keo is it cool if I send them to TurboTank for testing? I'll start building another set for you (and for myself) while we are awaiting feedback on this first set.

that's cool, I wanted the 1 piece one anyways! lol

I got a car ready to go for these too.

Ok...I just ordered one of the gauges needed to index the bends so they can be made in one piece. I need one more gauge and I'll grab it later this week.



Gotcha, I'll give turbotank first dibs on the prototype and we'll go from there. Pricing on these is going to be $250 for a set in raw steel. The pricing is for fabricating the linkage only...I'm not recouping any of the design time in the fixtures or reverse engineering the parts

Would this fit a P11 with the B15/P11 70 Series trans?

yes it should.

The prototype set is on the way to TurboTank. I also received the hardware needed to start prototyping the one piece design earlier this week. I'll post pics soon.

I wish I had a need for this so I could put a set on my car. They look so nice.

checking to see if Chris had a chance to test fit yet. I'm about to pull my B13 into the garage.