Thread: Adjustable B13 Rear LCAs, gauging interest.

A roll bar would be doable...I can add that to the development to do list.



Yes sir, the plan is to design/fab something that would allow aftermarket seats to be used on stock seat frames.



Looking good! After you get everything where you want it, let me know how far the rod end extends from the lower control arm. I don't have the #s on me at the moment, but there is a tolerance of thread engagement between the rod end/control arm that should always be used for safety. If it's out of range, I can make a custom set to fit your setup and swap what you have for the custom pieces.




Got it. I will start working on these this weekend

Anyone know what the length of the HUGE bolt that goes through the p10 hub for these? The NX is 205mm and the gtir is 230mm. I can only find stock of the nx bolt, so I'm sorta screwed... Everyone knows how much these bolts like to seize up.

I've also tried to find an off the shelf metric replacement, but an m14 230mm bolt is not really that common.

They look like Work Equip (05?) to me. Not sure on the rest though.

Edit: Nevermind see below.

Impul RS 17x8/9. Forgot the offset.

+35

You might be able to find the hardware at Maryland metric...they have a nice selection of metric stuff.
MARYLAND METRICS 'HOME PAGE'

The GTiR arms are starting to take shape

GTiR rear adjustable links/control arms are done!

nice

Awesome. If I can get some buyers together are you interested in a group buy for these?


Also, would you consider offering delsphere ends for these instead of rod ends?

Del-Sphere Pivot Joint | Roto-Joint | Johnny Joint

They come in left and right handed 3/4-16 thread with a 1.3425" ball width and a 3/4" centre hole. They would need different spacers but I'm sure that you could use the above measurements to have a good idea if you could modify your existing spacers or not. I'm curious to see what you have to say about them.

Also let me know about payment so I can get these to trial them on the GTiR. If they go over well I expect that you will have more buyers from overseas.

I'm also interested in a front LCA with the same sort of adjustability. PM me so we can talk.

Thanks! I am definitely interested in a group buy. Once I know how many are interested, I can run the numbers and figure out price breaks.

Serviceable rod ends are an interesting idea. I don't have any experience with them though. I would love to get my hands on these to see how they perform and how well they are made. I'm also interested in the specs...load ratings, tolerances, etc. Custom spacers will be no problem, we can machine them in house

I'll send over a PM with pricing info for the alpha run of GTi-R arms here shortly.