Thread: SR20 Turbo 02 Housing R&D

i have one on my VE-T , i love it.

Just an idea:
"Caution: Open Flame"

Would you consider a design without the waste gate...just a 3" exit?

Thanks! I've definitely thought about incorporating a cutout valve into the side exit along with "y-ing" into the stock exhaust. There is plenty of room...just need to find a cutout that works well. I have some issues in the past with them not sealing all the time.

I plan on designing the trim plates so that they can be personalized and are built to fit the customers setup. We are in the process of setting up a CNC plasma table which will make this a possibility.

Here's a few pics of the progress on the build over the last couple of weekends.

Light weight dimple die'd bracing for the tubing




Shot from underneath the front end


Tweaked the trim plate a little and made it a bit more symetric with less rivet holes


]

Up next will be supporting the tubing using some adjustable heim joints that run from the motor/block...should work great!

Nice.....no really streetable but sexy as hell

...Streetable in TX...

This beauty is finished and ready to go minus the trim plate.

Here's the beginning of the brace that mounts the exhaust to the block. It's super light weight, uses rod ends, and can be adjusted for pre-load.


Angle mock up


Exhaust brace

Can you fix the broken picture links?

This is rather cool. Did you finish the bumper plate? I'm curious.

I miss looking at the pics of your beautiful work....donde es?

They were linked from the facebook page which changed for some reason...I'm going to have to dig for them. I'll upload the pics to my site and update the links.



Not yet. I have CAD design finalized which could cut at any time. However, I picked up a PlasmCam CNC table a few months back and plan on using it cut this plate out. I'll also be using it make other cool parts for our cars

Here's a pic of the table after I unloaded from the trailer...I might need a bigger garage!




They are on the way!