Originally Posted by
KennyX The result is not so good at the moment, im experienced some loss sync issue when rev the engine more than 2k rpm .. trying to find out the problem ..
Anyway, im now running on the hand-cut 360/8-2-2-2 disc to become 36/1 , use jb weld to cover up the rest of extra slot ... engine's responsive is great ... signal stay clean til 8300 rpm ... i didnt go any further on my 16ve cam.. now doing other wheel patterns testing which i got them fairy cheap from junkyard.
KennyX
did you get sync loss with the 360 / 16-12-8-4 wheel? can you post up pic of your log? sync was ok for me, but I didn't do much high rpm testing. I think I only went to 5k iirc before I tore down the wiring system. are you using the VR circuits? (opto may not cut it).
and thank you sir for the pwm table explanation for vvl selenoids.