Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: Consult plug pins

+ Reply To Thread
Posts: 1-4 of 4
2009-05-06 23:33:53
#1
Consult plug pins
Hi!

Any person can help me about consult plug identification pins?

Pic:



What is the:
- CLK pin.
- TX pin.
- RX pin.
- Check pin is for the check light?


Thanks!
2009-05-07 16:11:36
#2
Ok! I found this:

Nissan Consult Port Pins

Use the above diagram as a reference. Splice each wire to the corresponding wires listed below.

SR20DET J2/J3/E4/E5 Pin Diagram

SR20DET J4/J5 Pin Diagram


Splice:
1) Rx wire (Receiver) to ECU’s Green wire with Black Stripe (pin 7)
3)Tx wire (Transmitter) to ECU’s Green wire (pin 15)
4) +12V wire (Power) to ECU’s Black wire with White Stripe (pin 38 or 47)
5) GND wire (Ground) to ECU’s Black wire (pin 39 or 48)
6) CLK wire to ECU’s Green wire with White Stripe (pin 14)

Software:
You can buy software to diagnose your engine (ie: Nissan Datascan, which is worth every penny, costs $100+), but there are free options available. Check out ECUtalk.
2009-06-08 03:38:59
#3
For 1999 G20 OBD2 ECU:

RX to pin 64
TX to pin 65
CLK to pin 68



For 1993 B13 SE-R OBD1 ECU:

RX to pin 7
TX to pin 15
CLK to pin 14

2009-06-13 01:01:37
#4
how do i wire a ODB1 ecu into a ODB2 connector?
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top