Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: Dial indicator mounting

+ Reply To Thread
Posts: 1-2 of 2
2016-02-07 14:54:45
#1
Dial indicator mounting
Hey guys

What kind of dial indicator mounting solutions are you using when degreeing a sr20 engine? Are there any kits out there that bolt right up to our engines?

some pictures would be great if anyone has some.
2016-02-14 14:17:20
#2
Just in case anyone stumbles upon this thread in the future i wanted to document my solution.

I went with a magnetic base for the dial indicator mounting. Unfortunately we have aluminum heads so I need a way to make it magnetic...

I got a thin sheet of steel, cut it to a 4inch x 2inch rectangle. I then drilled two holes along each long edge that match up with the valve cover bolts.

Now i just screw in two valve cover bolts and a few washers and i have good mounting solution for my dial indicator gauge.

The picture is a little rough but you get the point

Last edited by D-Unit121 on 2016-02-15 at 16-44-40.
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top