Thread: **Z32 Calipers in a B13**

There is a 11.75 inch kit for the B13 and B14 on Gspec that uses the NX calipers and a off the shelf rotor IIRC. Too bad the bracket is for the NX's and not the Z32's

This is a garbage kit. I am running it now and the calipers dont even hit the entire pad. It looks awesome under my 16" wheel and works pretty good with the altima mc upgrade but to us guys who know what it supposed to do it is stupid. I cant wait to get these off the car.

Thats good to know ... I was told they were the same. Anyone know for sure??

I would think for the re-welded knuckles somewhere in the $75-$100 per side range with the core

Also the Fastbrakes willwood kit uses corrado rotors which are only 22mm so the 26mm will work fine.

you were right about the hubs not being splined for the wheelstuds. i installed my H&R wheel spacers and studs yesterday....saw the truth: just holes.

I'd like to see where all this goes. I'd be down for a 11" rotor using Z32 calipers, if I'm understanding everything right. They would look nice under my new 16's I have coming.

With 16" wheels you could probably do a 11.75" rotor

you can w/ the fastbrakes setup, so the same is probably true here.

anyone ever thought of having a machine shop redrill the b15 hub and u13 rotor for 4x100? then simply install studs and run b14 wheels all day long

I thought that was mentioned above. It still leaves you with that issue above.