Thread: **Z32 Calipers in a B13**

Get the aluminum 26mm ones, not the cast iron calipers. The 26mm ones are barely heavier than the NX calipers. The rotors are also just a lil bit heavier, since the NX rotors are not light cause they are super thick.

i couldnt find aluminum, but i did find metal calipers

cant believe it. 2wks ago when i got mine off ebay there were 4 other sets now there nothing

thanks for the great info, i think ill be doin this setup for my race car. Sweet info

for those who want 4x114.3 all around use g20 rear hubs it bolts into your rear b13 spindle and this is a fact not speculation

ive got universal 4 lug 15" wheels so it should be fine, already knew about the G20 rear hubs, But again good info for this thread. Should be a fairly cheap setup comparable to the fastbrakes or willwood setups.

I can pick up a set of front knuckles w/hubs for less than 100.00 and then the calipers for probably 100.00 then its just the pads and rotors which should be fairly cheap. So your talking a whole new front brake setup for probably around $350 or so, Also got my ss lines for all 4 corners for 60 shipped brand new. So hell yeah a really powerful 410.00 setup. several hundred dollars less than a used willwood or fastbrakes kit. So who knows i might be able to get these for less than that as well. Have to find out when i go to Mexico to pick up my b15 trans and now i can grab the hubs as well.

Should be able to stop my 130+mph trap speeds pretty darn good compared to the cheezy stock setup. haha

P10?

Will 15" rims clear? or just 16's?

What is the cost and performance comparisons to the wilwood setup?

deleted

it fits 15"s just fine i have it on my b12. will post pics up later. just need to run a spacer to clear my spokes

pics