Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: How To: Prothane Motor Mounts

+ Reply To Thread
Posts: 101-103 of 103
2011-12-13 11:54:52
#101
You know to make install a little easier I used a hydraulic jack and my dads truck.
Placed the mount on the jack and lifted it up as if I was going to jack up the truck.
With the weight of the truck and all that it presses it in like nothing and that way you don't have to wrestle with the lip on the mount or worry if it's going in straight.
2011-12-17 20:48:16
#102
What do stock mounts look like? I think I may have some type of aftermarket performance mounts on my SE-R. My car at idle vibrates like a motherfucker too. That new passenger mount in Vadim's pics looks just like the one I have now.
2013-12-15 23:42:19
#103
Little tip to everyone doing this on a vise... Grease is your friend for starters.. Ok so before you put it in, take out the center metal. Now start it on the vice and center it but do it to where the top will go in first. Now while you still can take the metal piece that goes in the middle and put it on the bottom of the vise(snug against the poly and vise) then crank on that vise and it'll pop right in.. Took me about 20 minutes of frustration till I did it this way and worked perfect!
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top