Thread: Beam Bending for the B14

I should be able to make it by noon or slightly before.
My buyer is flying in at 8:16 so I should be done by 9:45 or so.
I just wanted to throw that out because I knew we were on a timetable and didn't want to muck anything up.

Look forward to meeting everyone.
I'll probably ask a lot of questions since I'm new to the 200SX SE-R and want some ideas.

I need at least 3 people before noon. Two at 9 am just to be safe. Sometime I get them done really quick and it would be a shame to waste the morning and then have things run long in the afternoon.

I will try my damnedest to be there at 9am. So count me in on the first 3.

I think I could be there by 9am as well Steve.

zer099- I never heard back on the cost of the plane ticket.

Can we get everyone to post when they will arrive please?
Swiss 9am
Zer099 9am
Old Guy 9am

I SHOULD be there before noon.
As long as the guy's flight isn't delayed and traffic isn't completely BORKED.

I'm going to try and be there by 9am as well... Hey Dave, could you PM me? I was wondering if we could all meet up first somewhere in TN, or possibly I drive by?. I would like to leave Friday Night so that I can split up the trip a little bit and may need a place to crash.

Otherwise I'll have to leave early saturday morning 3am or so and get there in the morn. I had a person going with me and wouldn't mind the 6-7hr drive in one shot, but he cannot come anymore... and I don't think I can drive that long alone.

-Ameen

ps, I'm going to try and remove my sway bar this thursday... otherwise I'll just take it off down there.

Oh man! It's getting close!

I sent you a PM Ameen.

I have the tools They arrived on Wednesday.
Now all we need is Steve! I'll be picking him up at the airport on Friday.
Thanks to all of you who have followed through with this. I have seen many of these bending parties fall apart because people would not honor their committments.

well I said eff it... My friend Sam and I are just going to leave directly from Ohio at 2 or 3am and headed straight for Calhoun!

See you guys at 9am or so... I may need to just take my rear sway bar off on site... I don't think I'm going to have time to do it tonight.

Later yall.