Thread: Pull-A-Part Atlanta Metro

was at the north yard this morning. there are two se-rs there. a white one and a red one. the white one has a rebuilt head with new springs and retainers. it also ES motor mount inserts.

Were either of those SE-R front bumpers in good shape?

the white one did not have a front bumper at all, and the red ones bumper was laying on the ground in front of it, it may be a little scratched up but it appeared to be in good shape.

Wow a second one. It must have come in this week. The Se-r's are dying around these parts.

I looked at the inventory. The new sentra that arrived on 06/14/2010 must be this new white Se-R.

I wonder whats going on at the East and South lots. I haven't visited those in a while.

I was in the East lot last week.....nothing but 1.6's.

I need some motor mounts so I'm going to the N yard tomorrow. My solid aluminum mounts have shaken something loose, so I'll step back to something with some give. I hope things are still there!

speaking of motor mounts do any of you guys know where I could get some prothane inserts around Atlanta, preferably tommorow.
I know summit may have them, but thats on the other side of stockbridge, and I need to be on my way to braselton by 1pm.

did those se-r's have passenger side wheel bearings? need to go check em out..u comin to our side of town?

yes, the red one had a pefect passenger side wheel bearing with no play in it at all. the front sway bar is laying underneath it also, and the inner tail lights and trim piece is in the trunk.

Was at North yesterday. The red bumper was in what I would consider rough shape. Bunches of scratches and a small tear on the passenger side. Probably salvageable, but I'll keep looking.

The white SE-R with the head work had 214k miles. I'm heading back up tomorrow to grab the tranny as I'm looking for one without pop out. I'm thinking it's worth the gamble

Transmissions go for under $70 at Pull-A-Part. I was under the impression that Early Se-R and Regular Sentras shared the same front bumper. Why not just grab something from a 1.6? If they are different then its just gotta be the holes for the foglight bar. I figure you could just punch holes in the plastic if you have to.